Refrigerator ice maker hookup

Refrigerator ice maker hookup


Refrigerator ice maker hookup

Turn the cold water on the supply line clockwise to close.

Attach a 5/16-inch drill bit to your drill. You may also need a drill and a 1/2-in. But do clamp the tubing to the fridge. Cut a 3- to 4-in.

To straighten coiled tubing (not the entire roll have a partner hold the end of the tube flat on the floor, then push the roll against the floor while unrolling to the length you need to go through the cabinets. If you need to drill through floors or walls, check for air ducts, electrical wiring, plumbing or other possible impediments first. Next, calculate how many feet of 1/4-in. Plumb the fridge, soldered connection, the 1/4-in. Alternative refrigerator ice maker hookup connections, these photos show alternative ways to connect to the cold water pipe.

How to, hook Up a Water Line to a, refrigerator

You'll simply replace one of those cold-water fittings with a new 3-way angle stop, or add a tee fitting between the water supply shutoff valve and the pipe. Of coiled tubing that will remain coiled and stored behind the fridge when you push it back into place. It has a tiny shutoff valve that uses a sharp pointed metal rod to pierce the outer wall of the pipe when screwed inward.

Find your water supply lines beneath your sink. An Adapt-a-Tee is an ideal plumbing fitting for this purpose. If tightening the connection does not stop the leak, turn off the water, remove the connector and add additional thread-seal tape before reconnecting the water line. Avoid last-minute shopping trips by having all your materials ready ahead of time.

Twist the faucet supply line onto the female end of the adapter. Then decide which refrigerator ice maker hookup one of three refrigerator water line connection options you will use: a regular tee fitting that is soldered, a compression tee fitting or a saddle valve.

Refrigerator, plumbing The Family Handyman

Required Tools for this Project, have the necessary tools for this refrigerator water isotopic dating methods line DIY project lined up before you startyoull save isotopic dating methods time and refrigerator ice maker hookup frustration.

The kit provides you with the required parts to hook up a water line to your refrigerator. Normally the compression fittings come with the fridge.

Leave the excess water line behind the refrigerator. Wrap the female thread on the opposite end of the adapter with thread-seal tape. Most contain a saddle valve (which doesnt meet plumbing code in some regions) and some contain plastic tubing (which can dry, split and leak over time). In this kitchen, we ran the new refrigerator water line from under the kitchen sink through cabinets.

Copyright © 2018-2019. - All Rights Reserved.